Datacom Systems SS series SPAN Guide de l'utilisateur télécharger pdf (Page 37)

Initial Configuration 37

4.1.4.18 SET TCP PORT (SE TC PO)

This command configures the TCP Port (default 2370) parameter. Initially this should be done using

the serial port with a terminal application. The parameter is entered as shown:

SET TCP PORT (SE TC PO) [nnnnn]

Example:

# SE TC PO 17216

TCP Port is now updated.

4.1.4.19 SET UPGRADE (SE UP)

This command sets the FLASHutils service (default ENABLED) process. It is entered as shown:

SET UPDATE (SE UP) [OFF or ON]

Example 1:

# SE UP OFF

The FlashUtils protocol is now disabled.

Example 2:

# SE UP ON

The FlashUtils protocol is now enabled.

4.1.4.20 SET TELNET (SE TT)

This command sets the TELNET service (default ENABLED) process. It is entered as shown:

SET TELNET (SE TT) [OFF or ON]

Example 1:

# SE TT OFF

The Telnet protocol will be disabled at end of session.

Example 2:

# SE TT ON

The Telnet protocol will be enabled at end of session.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 109 110

Pas de commentaire

Datacom Systems SS series SPAN Guide de l'utilisateur Page 37