Datacom Systems D56 Guide de dépannage télécharger pdf (Page 48)

–4

–

3. If the number of digits that you need to enter in a data field is less than

the maximum digits available (for example, the phone number field), enter

the desired data, then press [

✱]

and the next data field number to be

programmed.

4. If you try to enter a non-existent field, the keypad will display EE or

Entry Error. Simply re-enter [

✱

] plus a valid field number.

Reviewing a Data Field/Erasing an Entry in a Data Field

Press [#] plus Field No. Data will be displayed for that field number. No

changes will be accepted in this mode.

To delete an entry in a field, press [

✱

] plus Field No. + [

✱

]. (Applies only to

fields

✱

40–

✱

44,

✱

88, and

✱

94).

Interactive Mode Programming (

✱

56,

✱

80,

✱

81,

✱

82 and

✱

83)

Typical prompt

displayed during

interactive mode

programming

Enter Zn Num.

(00 = Quit) 01

Zone Number ↑

Press [

✱

] plus interactive mode no. (for example,

✱

56). The Alpha keypad

will display the first of a series of prompts requesting entries.

A detailed procedure (with displays of prompts) is provided in later sections

of this manual.

Interactive Mode Used To Program

✱

56 Zone Programming Zone characteristics, report codes, alpha

descriptors and serial numbers

✱

80 Relay Programming 4229 or 4204 Relay modules, or Powerline

Carrier devices

✱

81 Zone List Programming Zone Lists for relay/powerline carrier

activation

✱

82 Alpha Programming Zone alpha descriptors

✱

83 Sequential Mode 5800 series transmitter serial numbers

Loading Factory Defaults

To load the factory defaults, enter the programming mode, press

✱

97, then

exit the programming mode.

Do not press

✱

97 to load defaults if any programming has been done

previously—data already programmed into the system will be changed!

✱

96 resets all the Subscriber Account numbers and CSID in preparation for

an initial download.

Programming System Setup Fields

The following program fields must be programmed before doing any zone

programming.

✱

22 RF SYSTEM 0

Enter 1 if 5881/5882 RF receiver is being used; enter 0 if no receiver is

being used. Default is 0 (none).

✱

25 WIRED ZONE EXPANSION 0

Use this field to select the type of expansion unit being used, as follows:

0 = none; 1 = 4219; 2 = 4229; 3 = 4204. Default is 0.

Exiting the Programming Mode

✱

99 allows re-entry into the program mode using Installer Code + 8 0 0.

✱

98 inhibits re-entry into the programming mode using the Installer code.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 103 104

Commentaires sur ces manuels

Pas de commentaire

Datacom Systems D56 Guide de dépannage Page 48

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Datacom Systems D56