Datacom Systems D56 Guide de dépannage télécharger pdf (Page 41)

–41–

Programming For The Remote Keyswitch

1. With one 2-line Alpha keypad (AM6139), enter the programming mode by

entering:

Installer code + 8 + 0 + 0 keys.

If RF zones, wired expansion, or a keyswitch will be used, data fields

✱

22 RF

SYSTEM,

✱

25 WIRED ZONE EXPANSION and

✱

30 KEYSWITCH ENABLE

must be programmed as required prior to continuing.

Note: If keyswitch is enabled, in menu mode

✱

56 the Zone Type (ZT) for

zone 7 will show “77”, and will not be accessible for programming.

2. Press

✱

56.

Note that this is an interactive programming mode. You will use it to

program zone 7 for alarm report codes and to program response time

(zone type will automatically show as “77”).

E n t e r Zn Nu m .

( 0 0 = Q u i t ) 0 1

Zone Number ↑

Upon entering

✱

56 mode, this prompt will

be displayed.

Enter zone number “07”.

Following this entry, press

✱

to continue.

Typical summary display

Zn ZT RC In RT

07 77 00 HW: 1

A summary display will appear, showing the

present status of zone 7's programming.

Zn = zone number;

ZT = zone type;

RC = report code for that zone;

In = input type of zone;

RT = response time for that zone.

Values displayed are the factory defaults for

zone 7 or, if this is not a new installation,

they are the currently programmed values.

↓

Zone Number

0 7 Z o n e T y p e

7 7

Zone Type ↑

To program zone 07, press [

✱

Zone type will be automatically displayed as

“77”, and no entry is required.

Press [

✱

] to continue.

0 7 Re p o r t Co d e

1 s t 0 3 2 n d 1 2 3 C

The report code consists of 2 hexadecimal

digits, each in turn consisting of 2 numerical

digits. For example, for a report code of

"3C", enter [0][3] for "3" and [1][2] for "C".

If necessary, refer to Section 23. SYSTEM

COMMUNICATION for complete informa-

tion on report codes.

Enter the desired numbers and then press

[

✱

] to continue.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 103 104

Commentaires sur ces manuels

Pas de commentaire

Datacom Systems D56 Guide de dépannage Page 41

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Datacom Systems D56